Filter
Top Products
Water inlet (cold water connection only)
Connect the hose to a tap with a 3/4” thread.
Installation should comply with local water authority and building
regulations’ requirements.
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window “A”. Should this occur, turn the
water tap off and refer to your Service Force
Centre to replace the hose.
Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent
leaks.
Do not connect to a hot water supply.
Water drainage
This appliance is designed to be permanent-
ly plumbed into your home's drainage sys-
tem using one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain
hose using the “U” piece” supplied.
Place the drain hose into
your standpipe, which
should have an internal
diameter of approximately
38mm thus ensuring there
is an air break between the
drain hose and standpipe.
52
Installation
A
P0352
P1199
U piece
supplied
P1074
30 cm (12")
38 mm (11.2)
standpipe
diameter
132984060.qxd 17/06/2005 15:59 Pagina 52