Filter
Top Products
24 technical specifications / installation
Drainage
- The connector at
the end of the flexi-
ble hose can be at-
tached to all
common types of
standpipe.
Attach the connec-
tor to the standpipe
with the hose clamp supplied with the
appliance
*
.
- Fit the U-piece on
the drainage hose.
Place everything in
a drainage point (or
in a sink) at a height
of between 70 and
100 cm. Ensure it is
positioned secu-
rely. Air must be able to enter the end of
the hose, to avoid any risk of siphoning.
The drain hose must never be stretched.
If it is too short, contact an engineer.
Electrical connection
This washing machine must only be
connected in single-phased 230 V.
Check the fuse size : 13 A for 230 V.
The appliance must not be connected
with an extension lead or multi-plug
adaptor.
Ensure that the plug is earthed and that
it is in accordance with current regula-
tions.
Positioning
Position the appliance on a flat and hard
surface in a ventilated location. Ensure
the appliance does not come into con-
tact with the wall or other furniture.
To move the appliance, proceed as fol-
lows :
To move your ap-
pliance, place it on
its rollers by pulling
the lever located at
the base of the ap-
pliance hard from
right to left. Once
the appliance is in
the desired position, push the lever back
to its original position.
Accurate levelling avoids vibrations, noi-
se and prevents the appliance from mo-
ving when running.
* depending on model
1
2
1
2
3