Filter
Top Products
installation electrolux 39
b) Hinges
To mount the hinges it is necessary to
drill two holes (dia. 35 mm, depth
12.5-14 mm depending on the depth
of door furniture) on the inner side of
the door. The distance between the
holes hobs fixing centres must be 416
mm.
The distance (B) from upper edge of
the door to the centre of the hole
depends on the adjacent furniture's
dimensions.
The required dimensions are given in
the picture C.
The hinges will be fixed to the door by
means of screws for wood (2-Fig. B)
supplied with the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by
means of the M5x15 screws (3-Fig. B).
The hinges can be adjusted to com-
pensate for possible uneven thickness
of the door.
To align the door perfectly it is neces-
sary to loosen the screw (3-Fig. B),
adjust the door and tighten the screw
again.
d) Counter-magnet (6)
The appliance is pre-arranged for a
magnetic closure of the door. To
enable a correct operation of this
device, it is necessary to screw the
counter-magnet (6) (steel disk + rubber
ring) into the inner side of the door.
Its position must correspond to the
magnet (4) on the appliance (see pic-
ture D).
If the door has to be opened from left
to right, invert the position of the plates
(7), the magnet (4) and the plate (5)
(Fig. B and E). Mount the countermag-
net (6) and the hinges (1) as previously
described.
Recommendations regarding the
construction and fitting of a base
when the installation requires an
integrated appliance to be raised.
Where the appliance has been raised
by mounting onto a wooden base pro-
vided by the installer. The material
used to construct the base should
have a non slip surface, be water
repellent and if possible be one solid
piece.
4
6
5
1
2
3
7
E
P0983
P0984
6
4
D
132969690_GB.qxd 13/09/2007 11.38 Pagina 39