Electrolux 64850LE Washer User Manual


 
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied with
the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Installation should comply with local water
authority and building regulations require-
ments. Check the minimum water pressure
required for safe operation of the appliance in
the chapter "Technical Data".
Water-stop device
The inlet hose is provided with a water stop device,
which protects against damage caused by water
leaks in the hose which could develop due to nat-
ural ageing of the hose. This fault is shown by a
red sector in the window «A» . Should this occur,
turn the water tap off and refer to your Service
Centre to replace the hose.
Water drainage
The end of the drain hose can be positioned in three ways:
1.
Hooked over the edge of a sink using the plastic hose guide supplied with the
machine.
In this case, make sure the end cannot come unhooked when the machine is emptying.
Installation
31