Filter
Top Products
14
Drying cycle complete / removing laundry
Once the drying cycle is complete, the END and CREASE GUARD dis-
plays light up. If the AUDIBLE SIGNAL button has been pressed, an au-
dible signal sounds intermittently.
3 The drying cycle is automatically followed by a crease guard phase
which lasts around 30 minutes. The drum rotates in intervals during
this phase. The laundry thereby remains relaxed and free of creases. The
laundry can be removed at any time during the crease guard phase.
(The laundry should be taken out towards the end of the crease guard
phase at the latest to prevent creases from forming.)
1.Open loading door
2.Before removing the laundry, remove lint from the micro-fine filter. It is
best to use a damp hand for this purpose (refer to “Cleaning and main-
tenance” section).
3.Remove laundry.
4.Turn the programme selector to OFF.
Important! After each drying cycle
– clean the micro-fine filter and fine strainer,
– drain the condensate tank
(refer to the “Cleaning and maintenance” section).
5.Close loading door.