Filter
Top Products
4
2 Setting Up
You will need a 3.5 inch SATA Hard Drive. Carefully follow these procedures to
install the hard drive into the enclosure.
Note:
For pre-installed Hard Drive EAGLE | CONSUS enclosure, please skip this
chapter and proceed to
Chapter 3:
Connecting the Drive.
EAGLE | CONSUS I-SERIES Front and Rear View
Power Switch – Turns the I-SERIES on or off
Hard Drive access light – Indicates drive activity
Power light – Indicates enclosure is on
RAID Indication – Indicates RAID mode is enabled
USB 2.0 port – Connects to a computer USB port or USB hub
Power supply socket – Connects to power adapter
5
Disk Installation
Attention:
Eagle Tech Computers, Inc. is not responsible for consequential damages, including
loss or recovery of data from your hard drive. If you are installing with a hard drive
that has data inside, we suggest you backup your data before proceeding to
installation process.
NOTE: Please skip this section if you are purchasing an Eagle | Consus External
Hard Drive System with pre-installed Hard Drives. Do NOT attempt to open the
external storage system. You will VOID warranty if the warranty seal is damaged.
1. Remove 4 screws from the bottom.
2. Slightly remove the Disk Mounting Try and disconnect the power cable from the
socket.