Filter
Top Products
4
INSTALLATION INSTRUCTIONS
Removing transit bolts
1. Before operating the washer,
remove the transit bolts(4ea)
along with the rubber.
If the bolts are not removed, it
may cause heavy vibration,
noise and malfunction.
2. Unscrew the 4 bolts with the
spanner supplied. Keep the 4
bolts and spanner for future use.
Whenever the appliance is
transported, the
transit bolts must be refitted.
3. Close holes with supplied cap
holders.
Location of your washer
• Check location where the washer will be installed. Make sure you have everything necessary for correct installation.
• Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.
• Do not place or store laundry products on top of washer at any times.
• Install the washer on the horizontal solid floor. If the washer is installed on an unsuitable floor,
it could make considerable noise, vibrate severely and cause a malfunction.
If the washer is not level, adjust leg up or down for horizontal installation.
• Ventilation openings must not be obstructed by carpeting when the
washer is installed on a carpeted floor.
• Leave some space (right & left : 1 inch, rear : 4 inch).
• In case of built-in installation, the distance between top of the washer
and bottom of upper plate should be at least 3mm.
Drain Hose
Washer
Laundry
Tub
Approx.
1 inch
Level adjustment
If the washer is installed on an unsuitable floor, it could make
considerable noise, vibrate and cause a malfunction.
Adjust the level of washer using adjustable legs.
• Please check if there is any gap between the four adjustable legs and the floor.
• Turning adjustable legs by the enclosed spanner, adjust the level of washer and make it sure that there is no
swaying of washer.
• After the adjustment is finished, turn the fixing nuts up
tightly so that the washer maintains the adjustment.
Make it sure that the washer does not sway when
you press down the four corners of the washer's top plate.
NOTE
There should be no swaying of washer and all the
adjustable legs should stick to the floor closely.
Fixing Nut
adjustable leg