Crosley CDE-8000GBL Clothes Dryer User Manual


 
Question
Is your lint filter full?
Did you properly sort your load of
laundry?
Do your clothes have excess static
electricity?
Did you overload your dryer?
Did you place any paper, tissue, or other
similar material in the load?
What to Do
Please refer to the manual section on cleaning the lint filter, and
please confirm that the lint filter is clean. It is important that the lint
filter is clean before each new load of laundry.
In order to reduce the amount of lint in a load of laundry, sort lint
producers (like a fuzzy white cotton towel) separately from clothes
that might catch lint (such as a pair of black linen pants).
See comments below under. There Is Static In My Clothes After
Drying.
Divide your larger load into smaller loads.
Sometimes a person might forget to take a piece of paper or a tissue
out of a pocket, and this paper, tissue, or similar material can cause
excess lint in a load of laundry.
Confirm that the pockets of pants, shirts, and other articles of clothing
are empty before washing and drying.
5. Problem: There Is Lint On My Clothes
Question
Did you use fabric softener?
Did you over dry the load of laundry?
Are you drying synthetic, permanent
press and blends?
What to Do
Try using a fabric softener to reduce static electricity.
Over-drying a load of laundry can cause a build up of static electricity.
Try using a fabric softener or adjust your settings and use a shorter
drying time.
These materials can cause static to build up in a load of dried clothes.
Try using a fabric softener.
6. Problem: There Is Static In My Clothes After Drying
Question
Are you using consistent heat settings
and consistent load sizes?
What to Do
The drying time for a load will vary depending on the heat setting, the
type of heat used (electric, natural or LP gas), the size of the load, the
type of fabrics, the wetness of the clothes and the condition of the
exhaust ducts and lint filter.
7. Problem: The Drying Time Is Not Consistent
Question
Is water found around cabinet cover
when opening the door?
What to Do
This is normal because this is condensed moisture by drying.
8. Problem: Water Is Found Around The Cabinet Cover When Opening The Door.
30