Filter
Top Products
10
STEP 3. Electrical Plug Connections
Following steps are several warnings and instructions concerning making the electrical connection for electric
dryers.
More detailed information concerning the electrical connection is provided in the manual section entitled Electrical
Requirements for Electric Dryer.
It is important that you thoroughly review that section and the remainder of this manual, before taking any steps to
install or use this dryer.
1. Use only a new UL listed No. 10 (copper wire only) three or four conductor power supply cord kit rated 240 Volts
(minimum) 30 Amperes and labeled as suitable for use in a clothes dryer.
2. A four-wire cord is required for manufactured (mobile) home installations and where local codes do not allow
grounding of this appliance through neutral.
3. Electrical Plug Connections.
4. For additional instruction on connecting the dryer to an electrical power source, please refer to this manual's
section on Electrical Requirements and Electric Dryer.
WARNING!
• Use a new UL listed 30 amp power supply cord.
• Use a UL approved strain relief.
• Disconnect power before making electrical connections.
• Connect neutral wire (white or center wire) to center terminal.
• Ground wire (green or bare wire) must be connected to green ground connector.
• Securely tighten all electrical connections
• See installation instructions for complete instructions.
• Failure to do so may result in fire or electrical shock.