Blomberg TKF 8431 A Clothes Dryer User Manual


 
9
EN
vapor.
Do not dry items cleaned with industrial
chemicals in the dryer.
Do not dry your unwashed laundry in the
dryer.
Items soiled with cooking oils, acetone,
alcohol, fuel oil, kerosene, stain remover,
turpentine, paraffin and paraffin removers
must be washed in hot water with plenty of
detergent before being dried in the dryer.
Garments or pillows bolstered with rubber
foam (latex foam), shower bonnets, water
resistant textiles, materials with rubber
reinforcement and rubber foam pads should
not be dried in the dryer.
Do not use fabric softeners and anti-static
products unless they are recommended by
the manufacturers of the fabric softener or the
product.
Do not dry the underwear reinforced with
metal parts in the dryer. If these metal
reinforcements loosen and break during
drying, they will damage your dryer.
Preparing laundry for drying
Check all laundry items before loading them
into the product to make sure that there are
no lighters, coins, metal items, needles and
etc. in their pockets or on any part of them.
Fabric softeners and similar products must be
used in accordance with the instructions of
the manufacturer of the relevant products.
All laundry must be spun at the highest spin
speed that your washing machine allows for
the laundry type.
Laundry may be tangled after washing.
Separate your laundry before placing them
into your dryer.
Sort your laundry according to their types and
thicknesses. Dry the same type of laundry
together. E.g.: fine kitchen towels and table
cloths dry faster than the thick bath towels.
Correct load capacity
A Consider the information in the "Programme
Selection Table". Always start the
programme in accordance with the
maximum load capacity.
C Adding laundry to the machine more
than the level shown in the figure is not
recommended. Drying performance will
degrade when the machine is overloaded.
Furthermore, your dryer and your laundry
can be damaged.
C Place your laundry into the drum loosely so
that they will not get tangled.