Filter
Top Products
17
EN
“Cupboard Dry”:
-Starts to illuminate when the drying degree
reaches “wardrobe dry” step, and remains
illuminated until the next step.
“Cupboard Dry Extra”:
Starts to illuminate when the drying degree
reach to “wardrobe dry extra” step.
“Ventilation”:
- Illuminates when the programme ends.
C Anti-creasing icon will light up at the end of
the programme if anti-creasing function is
active.
Changing the programme after the
programme has started
You can use this feature to dry your laundry
in a different program after your machine has
started to run.
For example;
Press and hold the “Start/Pause/Cancel”
button for about 3 seconds to “Cancel” the
programme in order to select “Extra Dry”
programme instead of “Iron Dry” programme.
Select the “Extra Dry” program by rotating the
program knob. Press “Start/Pause/Cancel”
button to start the program.
C If you select a new programme by turning
the programme selection knob while
your machine is running, then the current
program is cancelled and new programme
information is displayed.
Adding/removing laundry in
standby mode
In order to add or take out laundry after the
start-up of the programme;
1. Press the “Start/Pause/Cancel” button
to switch the machine to “Pause” mode.
Drying process will stop.
2. Open the door at Pause position and close it
again after adding or taking out laundry.
3. Press “Start/Pause/Cancel” button to start
the program.
C Any laundry added after the drying process
was started may cause the already dried
clothes in the machine intermingle with wet
clothes and the result will be wet laundry
after the drying process is over.
CLaundry may be added or taken out as
much as desired during a drying process,
but as this process will interrupt drying
continuously, it will extend the program
duration and increase energy consumption.
Therefore, it is recommended to add laundry
before the drying programme has started.
C If you select a new programme by turning
the programme selection knob while your
machine is in standby, then the current
program is cancelled and new programme
information is displayed.
Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing of
button while the programme is running. The
loading door and all button except the “On/Off”
button on the panel are deactivated when the
child-proof lock is active.
In order to activate the child-proof lock, press
on the “audio warning” and “anti-creasing”
buttons simultaneously for 3 seconds.
To start a new programme after the programme
is over or to interrupt the programme, the child-
proof lock should be deactivated. Press the
same buttons for 3 sec. again to deactivate the
child-proof lock.
Lock symbol will appear on the screen when
the child-proof lock is activated.
C Child-proof lock will also be deactivated
when the machine is restarted by pressing
the on/off button.
When the child-proof lock is activated:
• Display icons will not change even if the
position of programme selection knob is
changed while the machine is running or in
halt.
• If the child-proof lock is deactivated after
changing the position of the programme