Beko WMP 511W Washer User Manual


  Open as PDF
of 20
 
4/EN
Washing Machine / User’s Manual
A WARNING
Ensurethatthecoldandhotwaterconnectionsaremadecorrectly
wheninstallingtheproduct.Otherwise,yourlaundrywillcomeout
hot at the end of the washing process and wear out.
Tightenallhosenutsbyhand.Neveruseawrenchwhen
tightening the nuts. Open the taps completely after making the
hose connection to check for water leaks at the connection
points.Ifanyleaksoccur,turnoffthetapandremovethenut.
Retightenthenutcarefullyaftercheckingtheseal.Toprevent
waterleakagesanddamagescausedbythem,keepthetaps
closed when the machine is not in use.
2.5 Connecting to the drain
• Theendofthedrainhosemustbedirectlyconnectedto
thewastewaterdrainortothewashbasin.
A WARNING
Donotremovethetransportationlocksbeforetakingoutthe
packaging reinforcement.
• Thehoseshouldbeattachedtoaheightofatleast40cm,
and 100 cm at most.
• Incasethehoseiselevatedafterlayingitonthefloorlevel
orclosetotheground(lessthan40cmabovetheground),
waterdischargebecomesmoredifficultandthelaundry
maycomeoutexcessivelywet.Therefore,followthe
heightsdescribedinthefigure.
• Topreventflowingofdirtywaterbackintothemachineand
toallowforeasydischarge,donotimmersethehoseend
into the dirty water or do not drive it in the drain more than
15cm.Ifitistoolong,cutitshort.
• Theendofthehoseshouldnotbebent,itshouldnotbe
steppedonandthehosemustnotbepinchedbetweenthe
drain and the machine.
• Ifthelengthofthehoseistooshort,useitbyadding
an original extension hose. Length of the hose may not
belongerthan3.2m.Toavoidwaterleakfailures,the
connectionbetweentheextensionhoseandthedrain
hoseoftheproductmustbefittedwellwithanappropriate
clamp as not to come off and leak.
2.6 Adjusting the feet
A WARNING
Inordertoensurethattheproductoperatesmoresilentlyand
vibration-free,itmuststandlevelandbalancedonitsfeet.Balance
themachinebyadjustingthefeet.Otherwise,theproductmay
movefromitsplaceandcausecrushingandvibrationproblems.
Loosenthelocknutsonthefeetbyhand.Adjustthefeetuntil
theproductstandslevelandbalanced.Tightenalllocknuts
againbyhand.
A WARNING
Donotuseanytoolstoloosenthelocknuts.Otherwise,theywill
get damaged.
2.7 Electrical connection
Connecttheproducttoagroundedoutletprotectedbya13
Afuse.Ourcompanyshallnotbeliableforanydamages
that will arise when the product is used without grounding in
accordance with the local regulations.
• Connectionmustcomplywithnationalregulations.
• Powercableplugmustbewithineasyreachafter
installation.
• Ifthecurrentvalueofthefuseorbreakerinthehouseis
lessthan13Amps,haveaqualifiedelectricianinstalla13
Ampfuse.
• Thevoltagespecifiedinthe“Technicalspecifications”
sectionmustbeequaltoyourmainsvoltage.
• Donotmakeconnectionsviaextensioncablesormulti-
plugs.
B
WARNING: Damagedpowercablesmustbe
replacedbytheAuthorizedServiceAgents.
Electrical requirements
Beforeyouinserttheplugintothewallsocketmakesure
thatthevoltageandthefrequencyshownintheratinglabel
corresponds to your electricity supply.
Werecommendthatthisappliancebeconnectedtothemains
supplyviaasuitableswitchedandfusedsocketinareadily
accessibleposition.
Shouldthemainsleadoftheappliancebecomedamagedor
needreplacingatanytime,itmustbereplacedbyaspecial
purposemademainsleadwhichcanonlybeobtainedfroma
AuthorisedServiceAgent.
B
WARNING: Thisappliancemustbeearthed
Ifthefittedmouldedplugisnotsuitableforyoursocket,then
theplugshouldbecutoffandanappropriateplugfitted.
Destroytheoldplug,whichiscutoffasaplugwithabared
cordcouldcauseashockhazardifinsertedintoasocket
elsewhere in the house.
Themouldedplugonthisapplianceincorporatesa13A
fuse.ShouldthefuseneedtobereplacedanASTAapproved
BS1362fuseofthesameratingmustbeused.Donotforget
torefitthefusecover.Intheeventoflosingthefusecover,
theplugmustnotbeuseduntilareplacementfusecoverhas
beenfitted.Colourofthereplacementfusecovermustbethe
samecolourasthatvisibleonthepinfaceoftheplug.Fuse
coversareavailablefromanygoodelectricalstore.
 previous next