Beko WMP 511W Washer User Manual


  Open as PDF
of 20
 
15/EN
Washing Machine / User’s Manual
7 Troubleshooting
Programmecannotbestartedorselected.
• Washingmachinehasswitchedtoselfprotectionmodeduetoasupplyproblem(linevoltage,waterpressure,etc.).>>>
Tocanceltheprogramme,turntheProgrammeSelectionknobtoselectanotherprogramme.Previousprogrammewillbe
cancelled. (See "Cancelling the programme")
Waterinthemachine.
• Somewatermighthaveremainedintheproductduetothequalitycontrolprocessesintheproduction.>>>This is not a
failure; water is not harmful to the machine.
Machinevibratesormakesnoise.
• Machinemightbestandingunbalanced.>>>Adjust the feet to level the machine.
• Ahardsubstancemighthaveenteredintothepumpfilter.>>>Clean the pump filter.
• Transportationsafetyboltsarenotremoved.>>>Remove the transportation safety bolts.
• Laundryquantityinthemachinemightbetoolittle.>>>Add more laundry to the machine.
• Machinemightbeoverloadedwithlaundry.>>>Take out some of the laundry from the machine or distribute the load by hand
to balance it homogenously in the machine.
• Machinemightbeleaningonarigiditem.>>>Make sure that the machine is not leaning on anything.
Machine stopped shortly after the programme started.
• Machinemighthavestoppedtemporarilyduetolowvoltage.>>>It will resume running when the voltage restores to the
normal level.
Programmetimedoesnotcountdown.(Onmodelswithdisplay)
• Timermaystopduringwaterintake.>>>Timer indicator will not countdown until the machine takes in adequate amount of
water. The machine will wait until there is sufficient amount of water to avoid poor washing results due to lack of water. Timer
indicator will resume countdown after this.
• Timermaystopduringheatingstep.>>>Timer indicator will not countdown until the machine reaches the selected
temperature.
• Timermaystopduringspinningstep.>>>Automatic unbalanced load detection system might be activated due to the
unbalanced distribution of the laundry in the drum.
C
INFORMATIONS
Machinedoesnotswitchtospinningstepwhenthelaundryisnotevenlydistributedinthedrumtopreventanydamagetothemachineandto
itssurroundingenvironment.Laundryshouldberearrangedandre-spun.
Foam is overflowing from the detergent drawer.
• Toomuchdetergentisused.>>>Mix 1 tablespoonful softener and ½ l water and pour into the main wash compartment of the
detergent drawer.
C
INFORMATIONS
Putdetergentintothemachinesuitablefortheprogrammesandmaximumloadsindicatedinthe“Programmeandconsumptiontable”.When
youuseadditionalchemicals(stainremovers,bleachsandetc),reducetheamountofdetergent.
Laundry remains wet at the end of the programme
• Excessivefoammighthaveoccurredandautomaticfoamabsorptionsystemmighthavebeenactivatedduetotoomuch
detergentusage.>>>Use recommended amount of detergent.
C
INFORMATIONS
Machinedoesnotswitchtospinningstepwhenthelaundryisnotevenlydistributedinthedrumtopreventanydamagetothemachineandto
itssurroundingenvironment.Laundryshouldberearrangedandre-spun.
A WARNING
Ifyoucannoteliminatetheproblemalthoughyoufollowtheinstructionsinthissection,consultyourdealerortheAuthorizedServiceAgent.
Nevertrytorepairanonfunctionalproductyourself.
 previous next