Beko WMB 71031 PTM Washer/Dryer User Manual


  Open as PDF
of 54
 
14
EN
up light of the relevant step during which the
machine was switched into the pause mode
will flash.
WaituntiltheLoadingDoorcanbeopened.
OpentheLoadingDoorandaddortakeout
thelaundry.ClosetheLoadingDoor.Make
changes in auxiliary functions, temperature
and speed settings if necessary. Press Start /
Pause button to start the machine.
Canceling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be canceled. End /
Cancel light will flash continuously to notify that
the programme has been canceled.
Pumpfunctionisactivatedfor1-2minutes
regardless of the programme step, and
whether there is water in the machine or not.
After this period, your machine will be ready to
start with the first step of the new programme.
C
Dependingonthestepwherethe
programme was canceled in, you may
have to put detergent and softener again
for the programme you have selected
anew.
End of programme
“End” appears on the display at the end of the
programme. Wait until the loading door light
illuminatessteadily.PressOn/Offbuttonto
switch off the machine. Take out your laundry
and close the loading door. Your machine is
ready for the next washing cycle.
5 Maintenance and cleaning
Service life of the product extends and
frequentlyfacedproblemsdecreaseifcleaned
at regular intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals
(every4-5washingcycles)asshownbelow
in order to prevent accumulation of powder
detergent in time.
Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
C
Ifmorethannormalamountofwaterand
softener mixture starts to gather in the
softener compartment, the siphon must
be cleaned.
Wash the detergent drawer and the siphon
with plenty of lukewarm water in a washbasin.
Wear protective gloves or use an appropriate
brush to avoid touching of the residues in the
drawerwithyourskinwhencleaning.Insertthe
drawer back into its place after cleaning and
make sure that it is seated well.
Ifyourdetergentdraweristheoneindicatedin
the following figure:
C
Lift the rear part of the siphon to remove
it as illustrated. After performing the above
mentioned cleaning procedures, replace
the siphon back to its seating
and push
its front section downwards to make sure
that the locking tab engages.
Cleaning the water intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreign substances and dirt in the water to
enter the washing machine. Filters should be
cleaned as they do get dirty.
Close the taps. Remove the nuts of the water
intake hoses to access the filters on the water
intake valves. Clean them with an appropriate
brush.Ifthefiltersaretoodirty,takethemout
by means of pliers and clean them. Take out
the filters on the flat ends of the water intake
hoses together with the gaskets and clean
thoroughly under running water. Replace the
gaskets and filters carefully in their places and
tighten the hose nuts by hand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
items such as buttons, coins and fabric fibers
 previous next