Beko WMA 667 W Washer User Manual


  Open as PDF
of 36
 
EN
28
If your product is not supplied with an
emergency drain hose, do the following
asshowninthefigurebelow:
• Placealargecontainerinfrontofthe
filter to receive water flowing from
the filter.
• Loosenpumpfilter(anticlockwise)
until water starts to flow out of it.
Direct the flowing water into the
container you have placed in front
ofthefilter.Youcanuseapieceof
cloth to absorb any spilled water.
• Whenthereisnowaterleft,turnthe
pump filter until it is completely loose
and remove it.
• Cleananyresiduesinsidethefilter
as well as fibers, if any, around the
propeller region.
• Ifyourproducthasawaterjet
feature, be sure to fit the filter into
its housing in the pump. Never force
the filter while replacing it into its
housing. Fit the filter fully into its
housing;otherwise,watermayleak
from the filter cap.
4- Close the filter cap.
Close the two-piece filter cap of your
product by pushing the tab on it.
Close the one-piece filter cap of your
product by fitting the tabs on the bottom
into their positions and pushing the
upper part of it.
 previous next