Beko WMA 667 W Washer User Manual


  Open as PDF
of 36
 
EN
24
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Placethelaundryinthemachine.
3. Add detergent and softener.
Starting
1. Pressthe“On/Off”button(Figure
2-14).
2. Select the program and the
temperature.
3. Ifdesired(accordingtoyour
machine’smodel):
– selectanyauxiliaryfunction,
– adjustthespinspeed,
– setthetimedelay,
4. Close the loading door.
5. Press“Start/Pause/Cancel”button
(Figure2-10).
The display shows the time remaining
for the program to complete if time delay
is not set.
The display shows the time remaining
for the program to start if the time delay
is set.
6. Check if the Door Locked Symbol
(Figure3-13i)lightsuponthe
screen.
TheDoorLockedSymbol(Figure3-13i)
will light up if time delay is not set.
TheDoorLockedSymbol(Figure3-13i)
will fade if time delay is set.
Cancelling a program
1. Pressandholdthe“Start/Pause/
Cancel”button(Figure2-10)for
about3seconds;theStartsymbol
(Figure3-13j)willstartflashing.
2. The machine can discharge all
the water or can take in water for
3 times at most to cool down the
clothes and complete discharging
process.
Adding more laundry
• This is only possible under the
followingconditions:
– duringtimedelay,
C Youmayaddorremovelaundry
duringthetimedelay(untilthe
programstarts).Atthebeginning
ofawashingcycle(machineallows
adding more laundry during a future
step only if the water level is low
enough to open the loading door or
if the temperature in the machine is
low).
In order to add laundry after the
start-upoftheprogram:
1. Press“Start/Pause/Cancel”button
(Figure2-10).
2. Opentheloadingdoorandputin
more laundry.
3. Close the loading door.
4. Press“Start/Pause/Cancel”button
(Figure2-10).
Program is in rinse hold mode
C This process is shown with the
flashingspinsymbol(Figure3-13c)
andthestandbysymbol(Figure
3-13k)whichislitup.
If you wish to spin when the machine is
inthismode:
1. Adjust the spin speed.
2. Press“Start/Pause/Cancel”
button(Figure2-10).Theprogram
continues, pumps out the water and
spins.
3. Thestandbysymbol(Figure3-13k)
fades out and the start symbol
(Figure3-13j)lightsup.
If you want to discharge the water
withoutspinning:
1. Press“Start/Pause/Cancel”button
(Figure2-10).
2. Thestandbysymbol(Figure3-13k)
fades out and the start symbol
(Figure3-13j)lightsup.
3. The program continues and only
pumps out the water.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
Ifyouwanttore-spintheclothes:
1. Distribute the laundry in your
machine for a balanced load.
2. Select the spin program.
3. Adjust the spin speed.
6 Quick instructions for daily use
 previous next