Filter
Top Products
56 / EN
Washer-Dryer
Maintenance and cleaning
6.6.1 In order to clean the dirty filter and discharge the water:
1. Unplug the machine to cut off the supply power.
A
CAUTION
¾ Temperature of the water inside the machine may rise up to 90ºC. To
avoid burning risk, cleaned the filter after the water in the machine cools
down.
2 Open the filter cap.
Press the tab on the filter cap downwards and pull the piece out towards yourself.
6.6.2 To discharge the water:
a Pull the emergency draining hose out from its seat
b Place a large container at the end of the hose. Drain the water into the container by pulling out the plug
at the end of the hose. When the container is full, block the inlet of the hose by replacing the plug. After
the container is emptied, repeat the above procedure to drain the water in the machine completely.
c When draining of water is finished, close the end by the plug again and fix the hose in its place.
d Turn the pump filter to take it out.