Filter
Top Products
21 - EN
A Never use solvents, cleaning
agents or substances alike when
cleaning as these might cause fire and
explosion!
Water tank (Products equipped
with a condenser);
The moisture in the damp laundry is taken
from the laundry and condensed. Drain
the water tank after each drying cycle or
during drying when “Water tank” warning
LED comes on.
A Condensed water is not
drinkable!
C You can use the water in the water
tank in your steam irons or air
humidifiers.
A Never take out the water tank
when the programme is running!
Water tank may be located in two
different places as indicated below,
depending on the model of your machine.
Inside the drawer on the panel-
Inside the kick plate cover-
If you forget to drain the water tank, your
machine will stop during the following
drying cycles when the water tank is
full and the “Water tank” warning LED
will light on. If this is the case, press the
“Start/Pause/Cancel” button to resume
the drying cycle after draining the water
tank.
In order to drain the water tank;
1 Carefully remove the water tank by
opening the kick plate cover/pulling the
drawer.
2 Drain the water by opening the water
tank cover.
3 If there is lint accumulation in the water
tank cover, clean it and press to close.
4 Place the water tank into its seat.
Cover filter
Lint and fibres released from the laundry
to the air during the drying cycle are
collected in the “Cover Filter”.
C Such fibre and lint are generally formed
during wearing and washing.
C Always clean the filter after each Drying
process.
C You can clean the filter and filter area
by vacuum cleaner.
For Filter cleaning;
1 Take out the cover
2 Remove the cover filter by pulling it up
and open the filter.
3 Clean lint, fibre, and cotton raveling by
hand or with a soft piece of cloth.
4 Close the filter and place it back into its
seat.
Sensor (models equipped with
a sensor)
There are humidity sensors in your
machine that detect whether the laundry
is dry or not.
For sensor cleaning;
1 Open the cover of your machine.
2 Allow the machine to cool off if drying
has been carried out.
3 Wipe the metal sensors with a soft
cloth, dampened with vinegar and dry
them.
C Clean metal sensors 4 times a year.
8 Maintenance and cleaning