Filter
Top Products
6
EN
2 Installation
Refer to the nearest Authorised Service
Agent for installation of your product.
C Preparation of location and electrical
installation for the product is under
customer’s responsibility.
BInstallation and electrical connections
must be carried out by a qualified
personnel.
A Prior to installation, visually check if the
product has any defects on it. If so, do
not have it installed. Damaged products
will cause risks for your safety.
Appropriate installation location
• Install the product in an environment
which has no risk of freezing and is in a
stable and level position.
• Operate your product in a well
ventilated, dust-free environment.
• Do not block the air ducts in front of
and under the product with materials
such as long pile rugs and wooden
bands.
• Do not place your product on a long
pile rug or on similar surfaces.
• Do not install the product behind a door
with a lock, sliding door or a hinged
door which can strike the product.
• Once the product is installed, it should
stay at the same place where its
connections have been made. When
installing the product, make sure
that the rear wall of it does not touch
anywhere (tap, socket, etc.) and also
pay attention to install the product at a
place where it will stay permanently.
BDo not place the product on top of the
power cable.
• Keep at least 1.5 cm distance to walls
of other furniture.
Removing the transportation
safety assembly
ARemove the transportation safety
assembly before using the product for
the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum
that contains a piece of styrofoam. Hold
it from its section marked with XX.
3. Pull the nylon towards yourself and
remove the transportation safety
assembly.
A Make sure that you have removed
the transportation safety assembly
(nylon+styrofoam pieces) before using
the product for the first time. Do not
leave any items inside the drum.
Under counter installation
• A special part (Part no. 297 360 0100)
replacing the top trim must be provided
and installed by the Authorised Service
Agent in order to use the machine under
a counter or in a cupboard. It should
never be operated without the top trim.
• Leave at least 3 cm of space between
the side and rear walls of the product
and the walls of the counter/cupboard
when installing your product under a
counter or in a cupboard.
Mounting over a washing machine
• A fitting device should be used between
the two machines when installing above
a washing machine. The bracket (Part
no. 297 720 0100 white/297 720 0400
grey) must be installed by the Authorised
Service Agent.
• Place the product on a firm floor. If
it will be placed on top of a washing
machine, the approximate weight of
both machines may reach 180 kg when
they are full. Therefore, the floor must be
capable of carrying the load on it!
Connection to water drain;
In products equipped with a condenser unit
the water accumulated during the drying
cycle is collected in the water tank. You
should drain the accumulated water after
each drying cycle.
You can directly send the accumulated
water out through the water drain hose
supplied with the machine instead of