Filter
Top Products
20
EN
programme is running!
If you forget to drain the water tank, your
dryer will stop during the following drying
cycles when the water tank is full and the
“Water tank” warning light will turn on. If
this is the case, press the “Start/Pause/
Cancel” button to resume the drying
cycle after draining the water tank.
To drain the water tank:
1. Drain the water as shown on the
picturre .
2. If there is lint accumulation in the water
tank cover, clean it and press to close.
3. Place the water tank into its seat.
For the condenser
Hot and humid air in the condenser is
cooled with the cold air from the room. Thus,
the humid air circulating in your dryer is
condensed and then pumped into the tank.
C Clean the condenser after every 30
drying cycles or once a month.
To clean the condenser:
1. If a drying process has been carried out,
open the door of the machine and wait
until it cools down.
2. Unlock the 2 condenser locks after
opening the kick plate.
3. Pull out the condenser.
4. Clean the condenser by applying
pressurized water with a shower head
and wait until the water drains.