Filter
Top Products
19
EN
7 Maintenance and cleaning
Filter Cartridge / Door Inner
Surface
Lint and fibres released from the laundry to
the air during the drying cycle are collected in
the “Filter Cartridge”.
CSuch fibre and lint are generally formed
during wearing and washing.
C Always clean the filter and the inner
surfaces of the cover after each drying
process.
C You can clean the filter and filter area by
vacuum cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up
and open the filter.
3. Clean lint, fibre, and cotton by unravelling
by hand or with a soft piece of cloth.
4. Close the filter and place it back into its
seat.
C Clogging may arise on the filter surface
after using your machine for some time;
if this occurs, wash the filter with water
and dry it before using again.
C Clean the entire inner surface of the
door and door gasket by wiping with a
damp cloth.
Sensor
There are humidity sensors in your dryer that
detect whether the laundry is dry or not.
To clean the sensor:
1. Open the loading door of the dryer.
2. Allow the machine to cool down if drying
has been carried out.
3. Wipe the metal sensors with a soft cloth,
dampened with vinegar and dry them.
C Clean metal sensors 4 times a year.
A Never use solvents, cleaning agents
or similar substances when cleaning
since these materials can cause fire and
explosion!
Water tank;
The moisture in the damp laundry is taken
from the laundry and condensed. Drain the
water tank after each drying cycle or during
drying when “Water tank” warning light turns
on.
A Condensed water is not drinkable!
A Never take out the water tank when the