Filter
Top Products
17
EN
3. Press “Start/Pause/Cancel” button to
start the programme.
C Press “Start/Pause/Cancel” button for
3 seconds to cancel the programme
or turn the programme selection knob
in any direction to end the programme
while the machine is running. Water tank
and filter cleaning warning lights turn on
to warn the user when the programme is
cancelled by pressing the “Start/Pause/
Cancel” button for 3 seconds. However,
the warning lights do not turn on when
the programme is cancelled by turning
the programme selection knob. Only the
drying light turns on and the machine
remains in hold until a new programme
is selected and the “Start/Pause/Cancel”
button is pressed. Child-proof lock of the
machine should not be active in order
to perform these two operations. If the
child-proof lock is active, deactivate it
before performing these operations.
Adding/removing laundry in standby
mode
In order to add or remove laundry after the
programme starts:
1. Press the “Start/Pause/Cancel” button
to switch the dryer to “Pause” mode.
Drying process will stop.
2. Open the door at “Pause” position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to
start the programme.
C Any laundry added after the drying
process has started may cause the dried
clothes in the machine intermingle with
wet clothes and the result will be wet
laundry after the drying process is over.
C Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend
the programme duration and increase
energy consumption since the drying will
be interrupted continuously. Therefore, it
is recommended to add laundry before
the drying programme has started.
Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing
of button while the programme is running.
The loading door and all buttons except
the “On/Off” button on the control panel
are deactivated when the child-proof lock is
active.
Press the “Start/Pause/Cancel” and “Cancel
audio warning” buttons simultaneously for 3
seconds to activate the child-press lock.
To start a new programme after the programme
is over or to interrupt the programme, the child-
proof lock should be deactivated. Press the same
buttons for 3 sec. again to deactivate the child-
proof lock.
C Child-proof lock is deactivated when the
machine is restarted by pressing the On/
Off button.
C Press the relevant buttons for 3 seconds
to activate the child-proof lock. A long
beep will be heard and the child-proof
lock will be activated. A double beep
will be heard if you press any button
or turn the programme selection knob
while the child-proof lock is active. Press
the buttons for 3 seconds to deactivate
the child-proof lock. Single beep will
be heard and child-proof lock will be
deactivated.
A A double beep will be heard if you turn
the programme selection knob when
the machine is running and the child-
proof lock is active. If you deactivate
the child-proof lock without returning
the programme selection knob to its
previous position, the programme will
be terminated since the position of the
programme selection knob is changed.
The drying light turns on and the
machine remains on hold until a new
programme is selected and the “Start/
Pause/Cancel” button is pressed.
Finishing by cancelling the
programme
To cancel any selected programme:
Press “Start/Pause/Cancel” button for about
3 seconds. The “Filter cleaning”, “Water tank”
and “End/ Anti-creasing” warning lights will
turn on at the end of this period for reminding
purposes.
A As the inside of the dryer will be
excessively hot when you cancel the
programme while the dryer is running,
activate the ventilation programme to
cool it down.