Beko D2 8101 ES D2 8101 E Washer User Manual


  Open as PDF
of 33
 
27 - EN
then resume the draining process.
• Afterdrainingprocessiscompleted,
replace the plug into the end of the
hose and fit the hose back into its
place.
If your product is not supplied with an
emergency drain hose, do the following
asshowninthefigurebelow:
• Placealargecontainerinfrontofthe
filter to receive water flowing from
the filter.
• Loosenpumpfilter(anticlockwise)
until water starts to flow out of it.
Direct the flowing water into the
container you have placed in front
ofthefilter.Youcanuseapieceof
cloth to absorb any spilled water.
• Whenthereisnowaterleft,turn
the pump filter until it is completely
loose and remove it.
• Cleananyresiduesinsidethefilter
as well as fibers, if any, around the
propeller region.
• Ifyourproducthasawaterjet
feature, be sure to fit the filter into
its housing in the pump. Never force
the filter while replacing it into its
housing. Fit the filter fully into its
housing;otherwise,watermayleak
from the filter cap.
4- Close the filter cap.
Close the two-piece filter cap of your
product by pushing the tab on it.
Close the one-piece filter cap of your
product by fitting the tabs on the bottom
into their positions and pushing the
upper part of it.
 previous next