Beko D2 8101 ES D2 8101 E Washer User Manual


  Open as PDF
of 33
 
22 - EN
The same symbol will also be displayed
whenever any button is pressed while
the machine is child-locked.
To deactivate the child-proof lock,
press the 2nd and 4th auxiliary function
buttons for 3 sec.
“C:OFF”(Child-prooflockisdeactivated)
label appears on the screen.
Ending the program through
canceling
“Start/Pause/Cancel”button(Figure
2-10)ispressedfor3secondstocancel
theprogram.Startsymbol(Figure
3-13j)willflashduringcancellation.
After cancellation, the symbol of the
corresponding step at which the
cancellation was made will remain lit and
“End”willappearonthescreen.
Program in rinse hold mode
• This process is shown with the
flashingSpinSymbol(Figure3-13c)
and the lit up Standby Symbol
(Figure3-13k).
If you wish to spin when the machine is
inthismode:
Adjustthespinspeed.Press“Start/
Pause/Cancel”button(Figure2-10).
The program continues, pumps out the
water and spins. The Standby Symbol
(Figure3-13k)fadesoutandStart
Symbol(Figure3-13j)lightsup.
If you want to discharge the water only
withoutspinning:
Press“Start/Pause/Cancel”button
(Figure2-10).TheStandbysymbol
(Figure3-13k)willfade.TheStart
symbol(Figure3-13j)willlightup.The
program continues and only drains the
water.
End of program
When the program is finished, the
symbols of the relevant steps will remain
lit up and the auxiliary function, spin and
temperature data selected at the start-
up of the program will remain selected.
“End”willappearonthedisplay.
 previous next