Filter
Top Products
CUSTOMER CARE CENTER 800.898.1879 www.askousa.com
INSTALLATION INSTRUCTIONS
7. Turn on water supply.
Check for leaks at water faucet and
machine before proceeding. Be sure
the water taps are on before starting.
8. Prepare Washer/
Dryer for Use
Before using washer/dryer,
read owner’s manual
thoroughly. Save all instructions
for future reference.
Wipe inside and outside of washer/dryer with a damp
cloth before running to remove any dust or debris.
Run your empty washer/dryer through a complete wash
cycle before washing clothes. Check for water leaks and
proper operation during this
test run.
ASKO denies all liability if instructions are not followed
correctly.
4. Water Drainage
Water may be drained into a sink, drainpipe or standpipe. To prevent
siphoning, do not seal drain hose into drain outlet.
Wall or Floor Standpipe Drain System - The top of the standpipe
must be between 23” (60 cm) - 35” (90 cm) from the bottom of the
washer.
You should securely attach drain hose to keep water pressure from
allowing hose to come loose and leak on the floor.
5. Level Washer/Dryer
The front and rear legs may be screwed /unscrewed to level the
machine. To access legs, tilt machine backwards until it rests against
wall or other stable structure. Adjust legs up or down until washer is
stable and does not rock front-to-back or side-to-side when upright.
Once machine is level, tighten locknuts.
IMPORTANT:
For best
performance,
washer/dryer
must rest solidly
on a sturdy floor
or platform, with
minimum vibration.
6. Connect to electric power
Plug power cord into grounded outlet only (see Grounding Instructions
on page 3 for complete details). Be sure power is OFF at fuse box/
circuit breaker before plugging in machine for the first time. Plug cord
into outlet and turn power on at circuit breaker.
NOTE: Remove four
(4) shipping bolts
prior to plugging
machine into
electrical outlet.
Do not cut power
supply cord!
5
M
IN
.
6
0
CM
M
A
X
.9
0
C
M
A