Filter
Top Products
CUSTOMER CARE CENTER 800.898.1879 www.askousa.com
OPERATION INSTRUCTIONS
14
Cleaning the Detergent Dispenser Drawer
When detergent builds up in and around the drawer, remove the
drawer by pressing on the plastic part of the softener compartment
marked “PUSH” (Fig. 10A). Place under running water for a few
minutes to remove buildup. Clean and wipe out the area around the
dispenser with a damp cloth before replacing the drawer.
Tips
Do not use liquid detergent for pre-wash because the detergent will
wash out of the drawer. Use only (HE) powdered detergent in the pre-
wash compartment.
Use low-suds high efficient (HE) detergent made for front-loading
washers. For HE detergents, use only 1 – 2 tablespoons. Too much
detergent can leave residue on your clothing and damage the washer/
dryer.
Do not use hand-washing detergent, as it may foam too much and
damage your machine.
Do not over use Fabric Softener. Use 1 to 2 tablespoons only!
Reduce the amount of detergent for cold water washing, as it
dissolves less easily in cold water.
Do not exceed recommended amounts of detergent and softener, as it
will result in poor washing, rinsing, and drying efficiency.
For (HE) liquid detergent use, refer to page 13.
Operation
Using Your Washer/Dryer
Operating your ASKO washer/dryer correctly affects your wash and
dry quality and extends the life of the machine. Before using the
washer/dryer, make sure you are familiar with the proper load sizes
(See Load Types and Sizes, pages 11-12).
Add detergent and fabric softener according to directions (see Using
the Laundry Aid Dispenser, page 13), then check to make sure that:
• Detergent drawer is completely closed
• Plug is securely in the electrical outlet
• Water supply is on
• Machine door is closed securely
To start the Wash / Dry Program:
Press On/Off button.
Set Wash Program Knob to the desired program for your current load
(see Guide to Wash Programs, pages 11-12).
Turn Drying Time Knob to desired number of minutes. (See Wash and
Dry Programs, page 11)
Select options for Pre-wash or Extra Rinse if desired.
Add appropriate amounts of HE detergent and fabric softener into
dispenser.
Press Start to begin the cycle.
Note: For more information on correct use of controls, see
Understanding the Control Panel, page 8.
To start the Wash only program:
(see wash only programs, page 12)
Follow steps above, leaving Drying Time Knob set to 0.
Note: At end of program, door lock remains engaged for 2 minutes,
after which you can open the door.
To start the Dry only program:
(see wash only programs, page 12)
Turn Wash program knob to Dry position.
Set drying time knob to number of minutes of drying time desired.
Press Start.
Reset Program / Add Garment
To stop the machine after a program has started, turn Wash Program
Knob to Stop. To restart the program, reposition the Wash Program
Knob and
press Start.
TO ADD A GARMENT
• TURN PROGRAM KNOB TO STOP
• WAIT 2 MINS FOR THE SAFETY DOOR CATCH TO RELEASE
• ADD YOUR GARMENT (continued on next page)
• CLOSE DOOR SECURELY
Fig. 10A