Filter
Top Products
Page 17
ENGLISH
ENGLISH
W6641 W6641 AND AND W6661 ERRW6661 ERROR MESSAOR MESSAGESGES
Error messages will display in the LCD window if faults
occur while a program is in progress. The table below
defines each possible error message.
ERRERROR MESSAOR MESSAGEGE SOLSOLUTIONUTION
When this symbol flashes at the lower right corner of the display it merely means
the glass door isn’t closed securely. Close the door and try again.
0000 If this message flashes at the top right of the LCD window, the machine has failed
to spin. This could be because the load is out of balance. Turn the power off
then on again. Open the door and redistribute the washing. Run the Spin
program again.
Door lock fault Call a service technician.
Foaming Run the Rinse program again.
Try using less detergent and softener.
Use low-sudsing detergents. (See page 8.)
Overflow Call a service technician
Pressure sensor fault Call a service technician.
Temperature stop fault Call a service technician.
Thermistor fault Call a service technician.
Wash motor fault Call a service technician.
Water inlet fault Make sure the water tap is open.
Water outlet fault Check the pin trap for possible blockage. Make sure the outlet hose isn’t kinked.
To remove the message, turn the power off or change
the program.
CHILD-SAFE STCHILD-SAFE STARART T BBUTTUTTONON
As a safety measure, you can program the W6641
and W6661 not to start unless the START button is
held down for three seconds. To do this, follow the
steps below:
1. Turn the machine off then on.
2. Press ENTER five times, then press P3 five times.
(This must be done within 15 seconds.)
3. “Delayed start” displays with “0” flashing in the
lower right corner. Press the right Arrow button to
toggle the display to “3.”
CHILD-SAFE MENU BUTTONCHILD-SAFE MENU BUTTON
Please note that when you set the child-safe Start button,
the Menu button is automatically programmed to delay for
three seconds before it becomes active. This prevents a
child from accidentally changing the program settings.
When you want to change a program, press the Menu
button for three seconds to activate the menus. The Menu
button will work normally (without the 3-second delay)
until you have completed your changes. If it is not pressed
for two minutes, it will automatically revert back to the
child-safe mode.