Filter
Top Products
Page 4
Height 33-1/2”–34-1/2 (850–876 mm)
Width 23-7/16” (595 mm)
Depth W6761: 23-7/16" (595 mm)
W6021/W6441: 24-7/16” (620 mm)
Weight 167 lbs. (73 kg)
Rated load See data plate
Supply voltage Single-phase 230 V, 60 Hz
Heating element 2000 W
Fuse 15 A (2 internal fuses)
ACCESSORIES
INSTALLATION INSTRUCTIONS
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
IMPORTANT NOTE:
Cosmetic damage must be reported to your dealer
within five days from the date of purchase. After
unpacking the washer, thoroughly check the unit for
cosmetic damage.
SPECIFICATIONS
Drum and Barrel Stainless steel
Outer casing Stove-enamelled hot-dipped
galvanized steel or stainless steel
Mounting Four adjustable rubber-covered
feet
Inlet supply hose 5 ft. (1.5 m) PEX tubing with
brass ferrules
Supply pressure 15–142 PSI
Outlet hose 5.5 ft. (1.7 m) polypropylene hose,
3/4” ID
REMOVING THE SHIPPING
SUPPORTS
The machine is transported with three shipping supports,
as illustrated below. These supports hold the tub in place
during shipment. When you unpack the machine, you
must remove these supports.
To remove the shipping supports, follow the instructions
below:
1. Unscrew the 5/8” (12
mm) bolts holding the
supports in place and
remove the bolts.
2. Push the rubber spacer
up then pull it out of the
slot.
3. Rotate the spacer so that the extruded end
points toward the machine.
4. Insert it into the
slot and push
down to lock it
into position.
You must remove the
shipping supports before
you install the washer.
LEVELING THE MACHINE
It is important that the machine is level so it won’t vibrate
excessively during the spinning cycles. Each foot on
the washer is adjustable, so you can level the washer
on any surface. Once it is level, securely tighten the
lock nuts on the feet to prevent excessive vibration during
the spin cycles.
WATER SUPPLY CONNECTION
Because ASKO washers have their own heating element,
you only need to have a cold water inlet. The connection
should be made by someone who is sufficiently skilled.
Use the hose supplied with the washer. (The inlet hose is
marked for proper connections.)
Water pressure must be in the range of 15–146 PSI.
A tap should be fitted on the water supply pipe.
If a new supply pipe has been installed for the washer, it
should be flushed thoroughly to remove any foreign
particles that might clog the strainer in the water inlet.
NOTE: If unit is installed on a second story, follow local
building codes. We recommend a drip pan be
installed.
2
1
Be sure to tighten the
lock nuts securely when
you level the machine.
Tap
Cold water
supply