Filter
Top Products
26
I. PREPARATION FOR OPERATION AND START-UP
The following items should be checked before attempting to operate the dryer:
1. Read ALL “CAUTION,” “WARNING,” and “DIRECTION” labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data label
affixed to the back side of the top front control and service door. In the case of 208 VAC or 230/240
VAC, THE SUPPLY VOLTAGE MUST MATCH THE ELECTRIC SERVICE EXACTLY.
3. GAS MODELS - Check to assure that the dryer is connected to the type of heat or gas indicated on
the dryer data label.
4. GAS & ELECTRIC MODELS -The sail switch damper assembly was installed and adjusted at the
factory prior to shipping. However, each sail switch adjustment
must be checked to assure that this important safety control is
functioning.
5. GAS MODELS - Be sure that ALL gas shut-off valves are in the open position.
6. Be sure ALL side and base panels are on the dryer.
7. Check ALL service doors to assure that they are closed and secure.
8. Be sure the lint door is securely in place.
9. Rotate the basket (tumbler and drum) by hand to be sure it moves freely.
10. Check bolts, nuts, screws, terminals and fittings for security.
11. Check to ensure all back guards and covers are on the dryer.
12. Check to ensure air supply is connected to the dryer (40 p.s.i.).
13. Check to ensure that all shipping blocks and braces have been removed.