Filter
Top Products
18
IMPORTANT: Failure to comply with these codes or ordinances or requirements stipulated in
this manual can result in personal injury or component failure.
NOTE: Component failure due to improper installation will VOID THE WARRANTY.
Each dryer should be connected to an independtly protected branch circuit. The dryer must be connected with
copper wire only. DO NOT use aluminum wire which could cause a fire hazard. The copper conductor wire/
cable must be of proper ampacity and insulation in accordance with electric codes for making ALL service
connections.
NOTE: The use of aluminum wire will VOID THE WARRANTY.
NOTE: Wiring diagrams are afficed to the inside at the top front control door and to the rear
upper back guard/panel.
F. ELECTRICAL INFORMATION
1. ELECTRICAL REQUIREMENTS
It is your responsibility to have ALL electrical connections made by a properly licensed and component
electrician to assure that the electrical installation is adequate and conforms with local and state regulations
or codes. In the absence of such codes, ALL electrical connections, material, and workmanship must
conform to the applicable requirements of the National Electrical Code ANSI/NFPA NO. 70-LATEST
EDITION, or in CANADA, the Canadian Electrical Codes Parts 1 & 2 CSA C22.1-1990 or LATEST
EDITION.