Filter
Top Products
PR
B. ADJUSTMENTS
7 DAYS AFTER INSTALLATION and EVERY 6 MONTHS THEREAFTER
Inspect bolts, nuts, screws (bearing set screws), nonpermanent gas connections (unions, shutoff valves, orifices,
etc.), electrical terminations, and grounding connections.
Motor and drive belts should be examined. A cracked or seriously frayed belt(s) should be replaced. Tighten
loose belt(s) when necessary and check the alignment.
Complete operational check of controls and valves.
Complete operational check of ALL safety devices (door switches, lint compartment switches, sail switches,
burner, and hi-limit thermostats).
C. LUBRICATION
The motor bearings, idler bearings, and under normal/most conditions the tumbler bearings are permanently
lubricated. It is physically possible to re-lubricate the tumbler bearings if you chose to do so even though this
practice is not necessary. Use Shell Alvania #2 grease or its equivalent. The tumbler bearings used in the dryer
DO NOT have a grease fitting. Provisions are made in the bearing housing for the addition of a grease fitting
which can be obtained elsewhere, or from ADC by ordering kit Part No. 882159 (includes two [2] fittings).