Filter
Top Products
OU
SECTION IV
OPERATING INSTRUCTIONS
A. STARTING THE DRYER
The dryer is available for use when the appropriate microprocessor controller (computer) light emitting diode
(L.E.D.) display reads “FILL” and/or the amount needed to start the dryer (i.e., “25”). Once the load has been
put into the dryer and the main door is closed, start the dryer as follows:
1. Insert the proper number of coins into the coin acceptor. Once the correct “Amount To Start” has been
inserted, the L.E.D. display will read “PUSH.”
2. Determine fabric setting (selection). Setting “HI TEMP” is the high temperature range, “PERM PRESS” is
the medium-range temperature setting, and “LO TEMP” is the low-range temperature.
Once the fabric temperature setting (selection) has been determined, start the dryer by pressing the fabric
setting key.
3. The dryer will now start, and the L.E.D. display will read the setting and the time vended (i.e., “LO 10”).
4. The cycle time will count down until the drying and cooling cycles are completed.
5. Upon completion of the drying cycle and cooling cycle, the dryer will shut off, the tone (buzzer) will sound
for 5-seconds, and the L.E.D. display will read “donE.”
NOTE: If the Anti-Wrinkle program is active, the L.E.D. display will remain reading “donE,”
and the microprocessor controller (computer) will proceed through the Anti-Wrinkle
program until the maximum “Active Guard Time” has expired or until the main door is
opened, whichever comes first.
NOTE: If the Anti-Wrinkle program is not active or in use, the L.E.D. display will read “donE”
until the main door is opened, at which time, the L.E.D. display will read “FILL” and/or
the “Amount To Start.”
a. Notes
1) The dryer basket (tumbler) can be stopped at any time by opening the main door. To restart dryer,
shut the main door and press desired setting.