Filter
Top Products
OR
H. PREPARATION FOR OPERATION
The following items should be checked before attempting to operate the dryer:
1. Read
ALL “CAUTION,” “WARNING,” and “DIRECTION” labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer’s data label affixed on
the back of the dryer control (service) door.
3. GAS MODELS - check to assure that the dryer is connected to the type of heat/gas indicated on the
dryer’s data label.
4. GAS & ELECTRIC MODELS - the sail switch damper assembly was installed and adjusted at the
factory prior to shipping. However, each sail switch adjustment must
be checked to assure that this important safety control is functioning.
5. Check bolts, nuts, screws, terminals, and fittings for tightness.
6. GAS MODELS - be sure that ALL gas shutoff valves are in the open position.
7. Be sure ALL back guard panels and service box covers have been replaced.
8. Check the lint door to assure that it is closed and secured in place.
9. Rotate the basket (tumbler) by hand to be sure it moves freely.
I. PREOPERATIONAL TESTS
ALL dryers are thoroughly tested and inspected before leaving the factory. However, a preoperational test
should be performed before the dryer is publicly used. It is possible that adjustments have changed in transit or
due to marginal location (installation) conditions.
1. Turn on electric power to the dryer.
a. COIN MODELS ONLY
1) The light emitting diode (L.E.D.) display(s) will flash back and forth between “FILL” and the
amount needed to start the dryer (i.e., “25”), meaning that the dryer is available and 25¢ is required
to start it.
2) Insert the proper number of coins into coin acceptor. Once the correct amount needed to start the
dryer has been inserted, the L.E.D. display(s) will read “PUSH.”
3) Start the dryer by pressing the desired setting (i.e., “LO” selection for the upper basket/tumbler).
The L.E.D. display will now read the selection (setting) made and the amount of time vended (i.e.,
“LO 10”).
NOTE: The dryer can be stopped at any time by opening the main door. To restart dryer,
shut the main door and press desired setting.