Filter
Top Products
9
SECTION III
INSTALLATION PROCEDURES
Installation should be performed by competent technicians in accordance with local and state codes. In the
absence of these codes, the installation must conform to applicable American National Standards: ANSI Z223.1-
LATEST EDITION (National Fuel Gas Code) or ANSI/NFPA NO. 70-LATEST EDITION (National Electrical
Code) or in Canada, the installation must conform to applicable Canadian Standards: CAN/CGA-B149.1-M91
(Natural Gas) or CAN/CGA-B149.2-M91 (liquid propane [L.P.] Gas) or LATEST EDITION (for General
Installation and Gas Plumbing) or Canadian Electrical Codes Parts 1 & 2 CSA C22.1-1990 or LATEST
EDITION (for Electrical Connections).
A. REASSEMBLY OF DRYER
IMPORTANT: Always keep the tumbler (basket) section of the dryer in an upright position
when moving it.
The AD-200 (gas model dryer) may be shipped
one of two ways; as a complete unit fully
assembled and ready for hookup or in two (2)
pieces with the middle frame separated from
the base. At installation, the middle frame will
be lifted onto the base. Use cables through the
eye bolts on top of the middle frame for lifting.
Fasten the middle frame to the base by using
the four (4) #3/8-16 bolts provided with the unit.
Also, reconnect the V-belts, belt guard at the
rear end of the unit, and reconnect the
electrical plugs located in the front control
boxes.
The ADS-200 (steam models) can also be
shipped with the middle frame separated from
the base. In this case, follow the instructions
for reassembly of the gas dryer. The steam
dryer may also be shipped with the steam coil
and damper piston removed. If this is the case,
lift the steam coil on top of the middle frame,
with the steam connection pipes facing the right
side of the unit, and bolt the coil to the top of the
middle frame using the #3/8-16 bolts provided.
Also, bolt the damper piston and solenoid valve
to the top of the middle frame using the bolts
provided. There are three (3) panels that cover
the front, right side, and rear of the steam coil.
Fasten these in position.