Filter
Top Products
Builder’s Guide for AMD Opteron™ Processor-Based
Servers and Workstations
30925 Rev. 3.04 February 2004
48
AMD Opteron™
Processor-Based System Build Procedure Appendix A
8. Install the assembled motherboard and processor with heatsink into the chassis. Always install
any standoffs needed to support the motherboard, especially in the areas where cards will be
placed.
9.
Check the motherboard for any jumper settings. (Most motherboards do not require jumpers.)
10.
Ensure the selected memory (256 Mbytes or more are recommended for server/workstations)
is shown on the motherboard maker’s recommended memory list. If the motherboard
manufacturer does not have a verified/recommended memory listing, check with the memory
supplier to verify that they have tested your chosen motherboard and deemed it to be
compatible with the DIMM memory modules you plan to use.
11.
Install the recommended memory into the motherboard. Be sure to install the RAM in the
sequence required for the chosen motherboard. Verify each memory DIMM is inserted all the
way into the socket and locked in place.
12.
Install a high-performance AGP video graphics card. Have the latest drivers available (see the
Web site of the card maker). You will need the drivers shortly.
13.
Connect the power cables to the drives and motherboard.
14.
Connect the hard drive, floppy-disk drive, and DVD (CD-ROM) data cables in the normal
manner. Verify that the cables are installed securely and with the proper edge near Pin 1.
15.
Connect the monitor data cable, keyboard cable, and mouse cable to the rear of the system.
16.
Install the AC-line power cord on the power supply and connect to the power outlet.
17.
Go to the Web sites of the motherboard vendor or the chipset maker for the latest drivers and
utilities.
18.
Check your motherboard vendor’s Web site for the latest version of the BIOS, AGP miniport
driver and bus mastering IDE driver. (AMD has drivers available for its chipsets at
www.amd.com. In EMEA, please go to http://www.amd.com/drivers.)
19.
Check the peripheral manufacturer’s Web site for the latest drivers for the sound card, network
interface card, the video graphics card, and any other added devices.
20.
Power the system on and begin loading software and drivers, following the installation
instructions.
21.
Make sure the system starts and runs reliably with just the graphics card installed. Restart and
run the system multiple times.
22.
Install additional cards at this time, if additional cards are to be installed.