Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
F232183
18
End of Day
1. Clean the AC drive box filters:
a. Snap off the external plastic cover which
contains the filter.
b. Remove the foam filter from the cover.
c. Wash the filter with warm water and allow to
air dry. Filter can be vacuumed clean.
2. Clean the door gasket of residual detergent and
all foreign matter.
3. Clean automatic supply dispenser and lid inside
and out with mild detergent. Rinse with clean
water.
4. Clean powder dispenser and lid with mild
detergent. Rinse with clean water.
5. Clean washer-extractor’s top, front, and side
panels with mild detergent. Rinse with clean
water.
6. Leave loading door open at the end of each day to
allow moisture to evaporate.
NOTE: Unload the washer-extractor promptly
after each completed cycle to prevent moisture
buildup. Leave loading door open at the end of each
completed cycle to allow moisture to evaporate.
Weekly
1. Check the washer-extractor for leaks.
a. Start an unloaded cycle to fill the washer-
extractor.
b. Verify that door and door gasket do not leak.
c. Verify that the drain valve is operating and
that the drain system is free from obstruction.
If water does not leak out during the prewash
segment, drain valve is closed and functioning
properly.
Monthly
NOTE: Disconnect power to the washer-extractor
at its source before performing the monthly
maintenance procedures.
1. Each month OR after every 200 hours of
operation, lubricate bearings. (Locate the bearing
lubrication decal at the rear of the left side of the
control module, as viewed from the front of the
washer-extractor.)
The grease must have the following
characteristics:
● NLGI Grade 2
● Lithium-based
● Water-insoluble
● Anti-rusting
● Anti-oxidizing
● Mechanically stable