Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
F232183
12
Table 2 lists the various displays and what they mean.
The operator should become familiar with these
computer displays.
Table 2
Display Indications
Display Meaning Display Meaning
vv01
Program identification code (ROM)
Example only.
SPC? Special test cycle function (if present, ignore)
Lo Low water level
Hold Wait...power has just been turned on.
nEd
Medium water level
CY Cycle (followed by two-digit number) HI High water level
tESt/CYC* Test cycle selected. SUP1 Supply 1
FAr Degrees Fahrenheit SUP2 Supply 2
CEL Degrees Celsius SUP3 Supply 3
HEAt Auxiliary heat enabled. SUP4 Supply 4
noHt Auxiliary heat disabled. SUP5 Supply 5 (SETUP option)
tFIL Temperature-controlled fill enabled. SUP6 Supply 6 (supply 1 and 5)
ntFL Temperature-controlled fill disabled. SUP7 Supply 7 (supply 3 and 4)
CooL Automatic cool-down enabled. SLo/For** Gentle wash speed, forward direction
noCL Automatic cool-down disabled. SLo/rEv** Gentle wash speed, reverse direction
Ag 1 Agitation 1 selected (90% agitation).
norn/For
Normal wash speed, forward direction
Ag 2 Agitation 2 selected (33% agitation). norn/rEv Normal wash speed, reverse direction
Ag 3 Agitation 3 selected (10% agitation). drAI Drain enabled.
Ag 4 Agitation 4 selected (6.7% agitation). nodr Drain disabled.
AgSn Agitation speed normal dISt Distribution (load balancing before extract)
AgSL** Agitation speed low
SPIn/tI
nE*
Reads “SPIn” for one second, then “tI
nE” followed by
time for spin.
PUnP
Pump output enabled (future use only).
nPnP
Pump output disabled (future use only). SPn1 Lowest of three spins
PrE PreWash segment (1st of 11 segments) SPn2 Middle of three spins
UASH Wash segment (2nd of 11 segments) SPn3 Highest of three spins
FIL1 First fill (3rd of 11 segments) STOP Stop routine
FIL2 Second fill (4th of 11 segments) SdLY Spin coast delay
FIL3 Third fill (5th of 11 segments) donE Cycle and stop routine have ended.
FIL4 Fourth fill (6th of 11 segments) dFLt Drive fault detected.
FIL5 Fifth fill (7th of 11 segments) door Door not properly closed.
FIL6 Sixth fill (8th of 11 segments)
BAL/door*
Indicates vibration switch or door locked switch tripped
during spin.
FIL7 Seventh fill (9th of 11 segments)
FIL8 Eighth fill (10th of 11 segments)
FILL/STOP*
Programmed water level not reached after
30 minutes.
FIL9 Ninth fill (11th of 11 segments)
CFIL Cold fill
FULL
The computer detects low water level or higher when
none should be present.
bFIL Warm fill (both hot and cold)
HFIL Hot fill
tSFL
Temperature sensor failure or temperature out of range.
AFIL Auxiliary fill (SETUP option) bAL? Special test cycle function (if present, ignore)
* Display indications separated by a slash represent a flashing display.
** The washer-extractor will operate at normal wash speed regardless of the speed settings.