Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
13
F232183
Start-Up
IMPORTANT: Remove all sharp objects from
laundry to avoid tears and rips to items during
normal machine operation.
Turn on the main power source (circuit breaker or cut-
off switch on the wall).
An identification code will appear for approximately
five seconds. Then the display will flash “Hold”
briefly.
The display will then read “CY” followed by a two-
digit cycle number (01 – 30) to indicate that a cycle
can be selected. This display will be shown at all times
when power is on between cycles, indicating that the
door-unlock solenoid will function if the door-unlock
button is pressed. Run the Test Cycle before operating
the washer-extractor. Refer to Test Cycle in the
Programming Manual. The machine is then ready for
loading and unloading.
Opening Door
Press and hold the door-unlock button and pull door
handle clockwise.
Loading
Load the machine to full capacity whenever possible,
but do not exceed the rated dry-weight capacity of the
machine if the fabric to be washed is quite dense,
closely woven, and heavily soiled. Overloading can
result in an inferior wash. Underloading can result in
poor load distribution potentially causing the extract
speed to be limited. The operator may need to
experiment to determine load size based on fabric
content, soil content, and level of cleanliness required.
NOTE: Underloading can cause out-of-balance
conditions which shorten life of bearing, seals,
basket/shaft assembly, etc.
When loading is complete, ensure that all fabric is
inside the basket. Then close and lock the door by
fully rotating the door handle counterclockwise. The
machine should not start or run unless the door is both
closed and locked.
NOTE: When washing items which may
disintegrate, such as mop heads or sponges, use
laundry net bags to prevent drain blockage.
Cycle Selection
NOTE: Press keys at their centers just hard enough
to activate them.
Press the Up or Down key until the desired cycle
number is displayed. The computer will skip blank
(unprogrammed) cycles automatically. Press the Start
key to start the cycle. For a more detailed description
of the preprogrammed cycles, refer to the cycle charts
at the end of the Programming Manual.
If the computer detects that the door is not properly
closed when the Start key is pressed, the display will
read “door” until the door is closed and locked. Press
Start again to begin the desired cycle.
Be careful around the open door,
particularly when loading from a level
below the door. Impact with door edges
can cause personal injury.
SW025
CAUTION
Never operate the machine with a
bypassed or disconnected balance
system. Operating the machine with
severe out-of-balance loads could result
in personal injury and serious equipment
damage.
SW039
WARNING
Check the door safety interlock daily
before the machine is placed in operation.
SW024
CAUTION