Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
23
F232123
When modifying a cycle, a time must be entered for
each segment. To skip a segment or spin, set the time
to “00” and press the Start key. Table 6 gives the time
parameters for each segment and spin, as well as the
allowable temperature range.
Table 6
NOTE: Spin times in cycle segments 1 – 10 are
entered in seconds (30 to 240), and time for final
spin in segment 11 is entered in minutes (1 to 10).
1. Press the Up key until the computer display
shows the segment to be edited. Press the Start
key.
2. Use the Up or Down key to select the desired
segment time. Set this value to zero to skip the
segment. Press the Start key.
NOTE: The computer does not count down the
remaining cycle time during fills, drains, cool-
down, or prior to first achieving the programmed
heat temperature when heating. The computer
resumes counting down cycle time once the
programmed fill level is reached, when the machine
has drained, and after a programmed heat
temperature is reached.
3. If the temperature-controlled fill setup option is
enabled, the display will show “tFIL.” Press the
Start key.
4. Use the Up or Down key to select the desired fill
temperature. Refer to Table 7 for fill options.
Table 7
If the temperature-controlled fill setup option is
enabled and a target temperature is set, the
selected fill valve(s) will energize for the first
three seconds of the segment fill. The computer
will then begin operating the fill valves in an
attempt to reach the target temperature. Press the
Start key.
5. Use the Up or Down key to select the desired fill
level. Refer to Table 8.
Table 8
Time and Temperature Parameters
Function Minimum Maximum
PreWash 2 minutes 30 minutes
Wash 2 minutes 20 minutes
Fill 1 2 minutes 15 minutes
Fill 2 2 minutes 15 minutes
Fill 3 2 minutes 15 minutes
Fill 4 2 minutes 15 minutes
Fill 5 2 minutes 15 minutes
Fill 6 2 minutes 15 minutes
Fill 7 2 minutes 15 minutes
Fill 8 2 minutes 15 minutes
Fill 9 2 minutes 15 minutes
Intermediate Spin* 30 seconds 240 seconds
Final Spin** 1 minute 10 minutes
Temperature 75°F (25°C) 200°F (93°C)
* Programmed with wash segment through Fill 8.
** Programmed with Fill 9.
Fill Temperature Options
Display Fill Type
CFIL Cold Fill
HFIL Hot Fill
bFIL Warm Fill
AFIL Auxiliary Fill*
*This is available only if the “SUP5”/“AFIL” setup
option is set to “AFIL.”
Water Level Options
Display Fill Level
Lo Low Level
nEd Medium Level
HI High Level