Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
17
F232123
Drain
If the cycle program segment calls for a drain, the
drain valves will open after the programmed segment
time has elapsed. If a spin step follows a drain step, the
cylinder will turn clockwise (forward) at wash speed
for several seconds at the beginning of the drain step.
This clockwise direction mirrors the spin rotation and
is, therefore, also considered forward.
The cylinder then accelerates to distribution speed to
help ensure that the load is evenly distributed. The
drains open several seconds later.
NOTE: The machine should drain in 30 seconds. If
the machine fails to drain, contact a qualified
service technician.
If the cycle program segment does not call for a drain,
the computer moves to the next segment of the cycle
program. If the segment is at the end of a cycle
program, the computer goes into the stop routine.
If the cycle program segment does not call for a spin,
the cylinder will continue to turn at wash speed
throughout the drain step. When the drain has
completed, the computer moves to the next segment of
the cycle program. If the segment is at the end of a
cycle program, the computer goes into the stop
routine.
NOTE: The drain step in the final segment (Fill 9)
cannot be skipped.
Spin
After the drain sequence ends, the speed of the
cylinder increases to the extract speed if the
programmed spin time is not zero. The displayed time
resumes counting down at one-second intervals.
After the programmed spin time has elapsed, the
computer moves on to the fill step in the next segment
of the cycle. If the spin is at the end of the cycle, the
computer begins the stop routine.
Stop Routine
When the computer concludes the wash cycle or when
the Stop key is pressed while a cycle is in progress, the
computer goes into the stop routine.
The stop routine sequence:
● All inputs are turned off
● A brief pause, allowing the cylinder to coast
down if in extract
● Brief rotation counterclockwise at wash speed
● A brief pause
● Brief rotation clockwise at wash speed
● A brief pause
● The display shows “donE”
● The door interlock is energized, allowing the
door to be opened
If the stop routine seems excessively long, check for
“FULL” or “rotA” messages. If this occurs, contact a
qualified service technician.
Once “donE” is displayed, open the door by pressing
and holding the door-unlock button as described
earlier. Once the door is opened, the computer display
will show the most recent cycle number.
The machine is now ready to begin another wash
cycle.
NOTE: A test cycle is provided as a means of
verifying proper machine operation. Refer to the
Programming section for instructions on running
the test cycle.
NEVER insert hands or objects into
basket until it has completely stopped.
Doing so could result in serious injury.
SW012
WARNING