Filter
Top Products
14
504607
Four-Wire Plug
4. Attach power cord ground (green) wire to rear
bulkhead using ground screw removed in Step 2.
NOTE: When installing the white wire, loop the
free eyelet end of the ground wire (removed in Step
2) and attach along with the white wire to the
neutral (center) terminal on the terminal block.
6. Tighten all screws and reinstall access cover
removed in Step 1.
D284IE0C
1. Remove access cover
from rear of dryer.
D287IE0E
GROUND
SCREW
2. Remove ground screw and
save for use in Step 4.
Remove wire and use in
Step 5.
D288IE0D
POWER
CORD
GROUND
WIRE
3. Use a strain relief
and insert end of
power cord
through power
supply hole.
D289IE0C
NEUTRAL
TERMINAL
RED
GREEN
WHITE
BLACK
5. Use the three screws from the envelope located
in the cylinder to attach the remaining power
cord wires to the terminal block as follows:
a. Red wire to “L1” terminal.
b. Black wire to “L2” terminal.
c. White wire to Neutral terminal.