Filter
Top Products
51
Installation
F232062
If the machine fails to operate after power is
connected, disconnect power and check the
control circuit fuse. Unlock and raise the top
cover. For mechanical timer, P-computer, and
S-computer models, the control circuit fuse is
on the center brace. For EDC and V-computer
models, dual control circuit fuses (1 primary
and 1 secondary) are in the control module. A
decal identifies the fuse (or fuses) in each case,
and provides the fuse rating appropriate to that
specific model.
If the control circuit fuse has blown, replace
with a fuse of the appropriate rating as
identified by the decal. Call a qualified
electrician if the replacement fuse blows.
Cabinet Hardmount
Electrical Specifications
80-Pound Capacity Models
Voltage Designation Standard Electric Heat
Code
Voltage
Cycle
Phase
Wire
Full Load
Amps
Circuit
Breaker
AWG
mm
2
Full Load
Amps
Circuit
Breaker
AWG
mm
2
3-Speed Models
A 208-240 60 3 4 15 40 6 16 90 100 1 45
C 380-415 50 3 4 9 20 12 4 41 45 6 16
D 220-240 50 3 3 14 40 6 16 89 90 2 35
F 440-480 60 3 3 9 20 12 4 46 50 6 16
O 208-240 60 3 3 15 40 6 16 90 100 1 45
W 380-415 50 3 3 9 20 12 4 41 45 6 16
Variable-Speed Models
F 440-480 60 3 3 4.49 15 14 2.50 N/A
O 208-240 60 3 3 12.4 20 12 4 87.46 90 2 35
Note:
Wire sizes shown are for copper, THHN, 90° conductor per NEC article 310.