Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
9001000
50
Electrical Connection
Remove the cover plate at the back of the machine.
Using copper conductors only, connect the power
cable to the connectors. Refer to the instructions listed
on the machine’s decal on how to connect the
machine.
After electrical installation is complete, run the
machine through a test cycle and check for clockwise
basket rotation during the extract step. If rotation is not
clockwise, disconnect the power from the machine and
have a qualified electrician reverse any 2 motor leads
at the AC drive terminal block.
Remote Liquid Supply Connection
Chemical Injection Supply System
Undiluted chemical dripping can damage the machine.
Therefore, all chemical supply dispenser pumps
should be mounted below the washer’s injection point.
All dispenser tubing should also run below the
injection point. Loops do not prevent drips if these
instructions are not followed. Failure to follow these
instructions could damage the machine and void the
warranty.
Figure 34
A connection has been placed at the back of the
machine. There are nine holes in this connection, through
each of which a liquid supply hose can be connected.
Dangerous Chemicals. May damage eyes
and skin. Wear eye and hand protection
when handling chemicals; always avoid
direct contact with raw chemicals. Read
the manufacturer’s directions for
accidental contact before handling
chemicals. Ensure an eye-rinse facility
and an emergency shower are within easy
reach. Check at regular intervals for
chemical leaks.
W363
WARNING
CFS492N
CONNECTION OF THE LIQUID SUPPLY HOSES
Drill out plugs and nipples before making
supply hose connection. Failure to do so
can cause buildup of pressure and risk a
tubing rupture.
W491
CAUTION