Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
41
9001000
Mounting Bolt Installation
(If Required)
After the concrete has cured and the anchors are
installed, proceed as follows:
1. Place the washer-extractor adjacent to the
foundation. Do not attempt to move it by pushing
on the sides. Always insert a pry bar or other
device under the bottom of the frame of the
washer-extractor to move it.
2. Place the washer-extractor carefully over the
anchors.
3. Put bolts through the machine in the anchors and
fasten them. (For the 18, 25, and 35 models, the
diameter of the bolt must be minimum 1/2-13 or
12 mm; for the 33, 40, 55, 75, 100, 135, 165 and
200 models, the diameter of the bolt must be
minimum 5/8-11 or 16 mm.)
4. To level machine, fill the spaces between the
machine base and floor with machinery grout.
Grout completely under all frame members.
Remove front and rear panels to gain access to all
frame members. Force grout under the machine
base until all voids are filled.
5. Remove the spacers carefully, allowing the
machine to settle into the wet grout.
6. Position washers and locknuts on machinery
anchor bolts and finger-tighten to machine base.
7. After the grout is completely dry, tighten the
locknuts by even increments – one after the
other – until all are tightened evenly and the
machine is fastened securely to the floor.
8. Remove the four red transport brackets which
secure the moving components of the machine
during shipping. Refer to Figures 29, 31 and 32
for typical transport bracket locations.
CFS485N
1 Base Frame
2 Bolt
3 Washer
4 Anchor Bolt/Plug
Figure 28
CFS485N
6 in.
(152 mm)
1
2
4
3