AEG W 808 Washer User Manual


 
Installation and connection instructions
42
Water inflow
A pressure hose of 1.35m in length is supplied.
If a longer inflow hose is required, only a VDE-approved, complete set
of hoses with fitted hose screw connections offered by our Customer
Service is permissible.
Hose sets in lengths of 2.2m, 3.5m and 5m are available for washing
machines without Aqua-Control.
Hose sets in lengths of 2.0m, 2.9m and 3.5m are available for washing
machines with Aqua-Control.
Important! Never cut into pieces in order to extend the hoses!
3
Sealing rings are supplied either in the plastic
nuts of the hose screw connection or in the enc-
losed pack. Do not use other seals!
0 1. Connect the hose with the angled connection to
the machine.
Important!
Do not lay the inlet hose verti-
cally downwards, instead run it
to the right or left as shown in
the diagram.
Tighten the hose screw connec-
tion only by hand.
2. Connect the hose with the
straight connection to a water valve with a
screw thread R 3/4 (inches).
Important! Only tighten the screw connection
manually.
3. By slowly opening the water valve before
putting the washing machine into operation,
check that the connection is free of leaks.