AEG 88810 Washer/Dryer User Manual


 
37
7.Open the porthole and remove the
polystyrene block fitted with the ad-
hesive tape on the door seal.
8.Fill the smaller upper hole and the
two large ones with the correspond-
ing plastic plug caps supplied in the
bag containing the instruction
booklet.
Important!
All the different plug caps are sup-
plied with the appliance in the plas-
tic bag containing the instruction
booklet.
Connect the water inlet hose as described under the paragraph “Water
inlet”.
Where to install
Important! The appliance must not be used in a room where there is a
danger of frost. Frost damage or impaired operation! Frost damage is
not covered by the warranty.
The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpets or on soft floor cov-
erings.
The surface on which the appliance is to be installed must be clean
and dry and free from coverings that move, so that the appliance
does not slide.
If the location in which the appliance is to be installed is fitted with
small-format tiles, put a rubber mat (available in the shops) under
the appliance.