AEG 88810 Washer/Dryer User Manual


 
34
Installation and connection instructions
1 Safety information for the installation
This washing machine cannot be built-in.
Before using for the first time, check the appliance for damage sus-
tained while it was being transported. Do not under any circumstanc-
es connect an appliance that is damaged. In the case of damage,
please contact your supplier.
Before using for the first time, all parts of the transport lock must be
removed. Otherwise when spinning damage may be caused to the ap-
pliance or to neighbouring units or furniture.
Before using the appliance for the first time, splash protection must
be completed. (See “Removing the transit packaging”.)
Always plug the mains plug into a correctly installed shockproof
socket.
Prior to using the appliance for the first time, ensure that the rated
voltage and type of supply on the rating plate match that of the sup-
ply where the appliance is to be installed. The fuse rating is also to be
found on the rating plate.
If work on the plumbing is required for the proper connection of the
washing machine to the water supply, this must be undertaken by a
competent person.
If work on the electricity supply system is required for the proper
connection of the washing machine to the electricity supply, this
must be undertaken by a registered electrician.
Should the appliance power supply cable need to be replaced, this
must be carried out by our Service Force Centre.
The power supply cable must be easily accessible after installing the
appliance.
Connect the machine to an earthed socket.
Installing the appliance
Transporting the appliance
1 Warning! The washing machine is very heavy. Risk of injury. Be careful
when lifting.