Filter
Top Products
– Before programme is started: appliance cannot be used
– After programme is started: programme in operation cannot be changed
The child lock
icon appears in the display to indicate that the child lock is activated. The
child lock is not deactivated once the programme comes to an end. If you want to set a
new programme, you must first deactivate the child lock.
SPIN SPEED
If the washing in the washing machine was initially drained prior to the drying cycle, the
dryer can be set according to the spin speed of the initial drainage procedure. The higher
the spin speed was, the shorter the programme length for the drying cycle.
Activate the SPIN SPEED option and then number of times press OPTION button until the
desired spin speed of the initial drainage is displayed. No value is shown if no spin speed is
selected.
In certain programmes the spin speed has no effect (time controlled cycles), its selection is
not possible and only three dashes are visualised. Available selections: from 800 to 1800
rpm's in 100 rpm's intervals.
The maximum value depends on the selected program, the minimum is always 800 rpm
For those programs where the spin speed has no effect (time controlled cycles), the selection
is not allowed and three dashes “- - -” are displayed that has the meaning of not set or
unknown.
The user interface always stores the last spin selection, and proposes it as default for all
new selected programs. If memorised spin speed is greater than maximum allowed value
it will be automatically reduced to max spin speed available for the selected program.
Selecting TIME
To select the programme duration after setting the TIME programme. You can select a
programme duration from 10 minutes to 3 hours in 10-minute steps.
1. Turn the programme knob to the TIMED PROGRAMME. The 0:10 minutes is in the display
(corresponding to the cooling phase).
2. Press the TIME button repeatedly until the desired programme duration is shown in the
display, e.g. 0:20 for a programme of 20 minutes.
If the programme duration is not selected, the duration is automatically set to 10 mins.
Selecting DELAY START
See chapter ProSteam system, section Selecting DELAY START.
Starting the drying programme
Press the START PAUSE button. The programme starts.
The progress bar and the name of currently performed phase, above it, show stage of the
cycle.
With wet laundry, after a few minutes the appliance will show the correct programme
duration and foreseen time of cycle end.
It is normal for the appliance to make noises during drying programme if garments with
hard parts, such as metal buttons, are put in the drum.
24
Drying