Filter
Top Products
fill up the steam water tank with distilled water. Otherwise, you will not be able to start
any ProSteam programme.
Pull drawer containing condensed water contain-
er out a little 1, then pull the water tank’s filler
neck 2
Important! Only fill the water tank with dis-
tilled or fully desalinated water. Do not use
tap water or additives! You can also use the
condensed water from the tank, as long as you
filter it first (use the canister supplied with
the filter fitted: see picture opposite).
Fill with distilled water from the canister provided,
up to the MAX mark inside the container.
Push filler neck and drawer with condensed water
container back in.
When dry, all textiles not specifically prohibi-
ted in the chapter ‘Sorting and preparing
laundry’ may be treated with the ProSteam
System. Wet textiles may only be treated if
they are labelled as suitable for dry pro-
grammes.
Water recirculation system
This system allows you to use for a ProSteam cycle the condensed water automatically
collected in the condense water tank during a drying cycle.
The water in the condense water tank will never automatically fill the steam water tank.
The water recirculation system works only if it is supplied by water arising during standard
drying cycles.
To activate this system turn the valve to the ON position. When the valve is ON the steam
water tank will be filled during the next drying cycle. Water will be supplied by the water
circuit directly to the steam water tank filling it automatically.
To activate recirculation set valve to the ON position. To do that:
1. Pull drawer containing condensed water
container out a little. Behind the drawer
there are two elements:
1 steam water inlet - for manual refill-
ing of steam water container.
2 water recirculation system valve/fil-
ter.
1
2
max.
ON
OFF
1 2
ProSteam system
13