Instructions for use
42
Program Saving
To protect a program setting against unwanted changes (e. g. turning
the program selector, pressing auxiliary buttons etc.), you can set the
program saving function. This prevents damage to your washing.
3
Setting and cancelling the program saving function is possible at any
time during a program.
Setting the Program Saving Function:
0 1. Set the required washing program.
2. To start the program, press the START/PAUSE (MARCHE/ PAUSE) button.
3. Simultaneously keep the PRE WASH (PRELAV.) button and the SOAKING
(TREMPAGE) button pressed for 5 seconds. The program sequence dis-
play flashes for 5 seconds; The program saving function is set.
3
You cannot make any other settings as long as the program saving
function is set. The door cannot be opened with the DOOR/LIGHT
PORTE/LUMIERE) button. Even after the washing cycle has ended, you
must first cancel the program saving function before you can open the
door.
If an attempt is made during the washing cycle to change the selected
setting by pressing a button, the program sequence display flashes for
5 seconds.
If an attempt is made to change the selected setting by turning the
program selector, the program sequence display flashes until the origi-
nal position of the program selector is restored. The washing cycle is
not influenced in either case.
3
The program selector must be in its original position before you can
cancel the program saving function.
Canceling the Program Saving Function:
0 Simultaneously keep the PRE WASH (PRELAV.) button and the SOAKING
(TREMPAGE) button pressed for 5 seconds. The program sequence dis-
play flashes for 5 seconds, then it lights up constantly for 5 seconds.
The program saving function is cancelled.